10 material differences · fewer than 12
Tractor oneFiat 750-S (DT)1971–1975No measured PTO figureTractor twoZETOR 8011/80451968–1987No measured PTO figure
Which should you choose?
Read our verdict on the 750-S (DT) and the 8011/8045 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 750-S (DT) | 8011/8045 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 78.9 hp | 78.9 hp | — |
| Engine declared | O.M.-FIAT CO 3/70 | ZETOR Z-8001 | differs |
| Displacement declared | 4.56 L | 4.56 L | — |
| Maximum torque declared | 231 lb·ft · 313 N·m | 196 lb·ft · 266 N·m | +18% 750-S (DT) |
| Transmission | |||
| Top speed declared | 14.9 mph · 24 km/h | 18.6 mph · 30 km/h | +25% 8011/8045 |
| Clutch declared | Dry FEREDO double clutch, type 12/12" | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.3 gpm · 27.5 L/min | — | — |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,275 lb · 3,300 kg | 8,611 lb · 3,906 kg | +18% 8011/8045 |
| Wheelbase declared | 96.1 in · 2,440 mm | 92.8 in · 2,358 mm | — |
| Length declared | 140.2 in · 3,560 mm | 163.0 in · 4,140 mm | +16% 8011/8045 |
| Width declared | 72.0 in · 1,830 mm | 77.3 in · 1,964 mm | +7% 8011/8045 |
| Ground clearance declared | 20.5 in · 520 mm | 12.4 in · 315 mm | +65% 750-S (DT) |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 11.2 ft · 3.41 m | +11% 750-S (DT) |
| Fuel tank declared | 85.6 qt · 81.0 L | 95.1 qt · 90.0 L | +11% 8011/8045 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 750-S (DT) sources
- Source: Traktorenlexikon, “Fiat 750 S/750 S/DT”
- Source: Traktorenlexikon, “Someca 750”
ZETOR 8011/8045 sources
- Source: Traktorenlexikon, “Zetor 8011/8045”