8 material differences · fewer than 12
Tractor oneFiat 750 (DT)1968–1971No measured PTO figureTractor twoSOMECA 800 (TD)1968–1971No measured PTO figure
Which should you choose?
Read our verdict on the 750 (DT) and the 800 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 750 (DT) | 800 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 75.0 hp | — |
| Engine declared | O.M.-FIAT CO 3/70 | O.M.-FIAT CO 3/80 | differs |
| Displacement declared | 4.56 L | 4.94 L | +8% 800 (TD) |
| Maximum torque declared | 206 lb·ft · 279 N·m | — | — |
| Transmission | |||
| Top speed declared | 14.9 mph · 24 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal-operated two-stage dry FEREDO double clutch | pedal-operated dry FEREDO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.3 gpm · 27.5 L/min | 9.9 gpm · 37.5 L/min | +36% 800 (TD) |
| Pressure declared | 2,843 psi · 196 bar | 2,611 psi · 180 bar | +9% 750 (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,713 lb · 3,045 kg | 6,614 lb · 3,000 kg | — |
| Wheelbase declared | 96.1 in · 2,440 mm | 93.7 in · 2,380 mm | — |
| Length declared | 153.9 in · 3,910 mm | 159.4 in · 4,050 mm | — |
| Width declared | 72.0 in · 1,830 mm | 76.2–99.8 in · 1,935–2,535 mm | differs |
| Ground clearance declared | 20.5 in · 520 mm | 13.6 in · 346 mm | +50% 750 (DT) |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 12.1 ft · 3.70 m | — |
| Fuel tank declared | 85.6 qt · 81.0 L | 85.6 qt · 81.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 750 (DT) sources
- Source: Traktorenlexikon, “Fiat 750/750 DT”
- Source: Traktorenlexikon, “Someca 750”
SOMECA 800 (TD) sources
- Source: Traktorenlexikon, “Someca 800”