12 material differences
Tractor oneFiat 72-94 (DT)1993–1996No measured PTO figureTractor twoVALMET 465 (465-4)1993–1997No measured PTO figure
Which should you choose?
Read our verdict on the 72-94 (DT) and the 465 (465-4) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 72-94 (DT) | 465 (465-4) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | Fiat-Iveco 8045.06 | VALMET 320 DS | differs |
| Displacement declared | 3.61 L | 3.30 L | +10% 72-94 (DT) |
| Maximum torque declared | 165 lb·ft · 224 N·m | 192 lb·ft · 260 N·m | +16% 465 (465-4) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 11.8 gpm · 44.5 L/min | 14.5 gpm · 55.0 L/min | +24% 465 (465-4) |
| Pressure declared | 3,263–3,408 psi · 225–235 bar | 2,901 psi · 200 bar | differs |
| Three-point lift, at the coupling points declared | 7,716 lb · 3,500 kg | 5,688 lb · 2,580 kg | +36% 72-94 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,628 lb · 3,460 kg | 6,217 lb · 2,820 kg | +23% 72-94 (DT) |
| Maximum permissible mass declared | 11,684 lb · 5,300 kg | — | — |
| Wheelbase declared | 92.1 in · 2,340 mm | 83.1 in · 2,112 mm | +11% 72-94 (DT) |
| Length declared | 139.8 in · 3,550 mm | 146.1 in · 3,710 mm | — |
| Width declared | 85.0 in · 2,160 mm | 79.9 in · 2,030 mm | +6% 72-94 (DT) |
| Ground clearance declared | 20.1 in · 510 mm | 15.9 in · 405 mm | +26% 72-94 (DT) |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 98.3 qt · 93.0 L | 77.1 qt · 73.0 L | +27% 72-94 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 72-94 (DT) sources
Source
- Source: Traktorenlexikon, “Fiatagri 72-94”
- Source: Traktorenlexikon, “Fiatagri 65-94”
VALMET 465 (465-4) sources
Source
- Source: Traktorenlexikon, “Valmet 465”