6 material differences · fewer than 12
Tractor oneFiat 715 (DT)1966–1969No measured PTO figureTractor twoInternational Harvester 7431980–1989No measured PTO figure
Which should you choose?
Read our verdict on the 715 (DT) and the 743 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 715 (DT) | 743 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 66.1 hp | 66 hp | — |
| Engine declared | O.M.-FIAT CO-2 D/70 | IH D-239 | differs |
| Displacement declared | — | 3.91 L | — |
| Maximum torque declared | — | 166 lb·ft · 225 N·m | — |
| Transmission | |||
| Top speed declared | 14.9 mph · 24 km/h | 18.6 mph · 30 km/h | +25% 743 |
| Clutch declared | Pedal operated dry FERODO double clutch | Dry dual clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.0 gpm · 26.5 L/min | 7.9 gpm · 30.0 L/min | +13% 743 |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,349 lb · 2,880 kg | 6,349 lb · 2,880 kg | — |
| Maximum permissible mass declared | — | 12,125 lb · 5,500 kg | — |
| Wheelbase declared | 86.6 in · 2,200 mm | 86.2–87.6 in · 2,190–2,226 mm | — |
| Length declared | 146.9 in · 3,730 mm | 148.4 in · 3,770 mm | — |
| Width declared | 77.2 in · 1,960 mm | 80.3 in · 2,040 mm | — |
| Ground clearance declared | 18.1 in · 460 mm | 18.0 in · 457 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 12.1 ft · 3.70 m | — |
| Fuel tank declared | 88.8 qt · 84.0 L | 78.2 qt · 74 L | +14% 715 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 715 (DT) sources
- Source: Traktorenlexikon, “Fiat 715/715 DT”
International Harvester 743 sources
- Source: Traktorenlexikon, “IHC 743”