Fiat 70-66 F (DT/F) or Renault 70-32 PX?
Which should you choose?
On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Fiat 70-66 F (DT/F) is ahead on drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 70-66 F (DT/F) | 70-32 PX | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 45.4 kW (60.9 hp)Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 45.3 kW (60.7 hp)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 70-66 F (DT/F) and the 70-32 PX. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 70-66 F (DT/F) and the 70-32 PX. |
| Which pumps more oil for implements? | — | 32.1 L/min (8.5 gpm)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | No figureNo call on hydraulic flow: no figure on record for the 70-66 F (DT/F). |
| Which lifts more on the three-point hitch? | 2,648 kg (5,838 lb)Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 2,870 kg (6,327 lb)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | Not comparableNot comparable on three-point lift: the 70-66 F (DT/F): lift 610 mm behind the hitch ends, as stated by the source (Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT”); the 70-32 PX: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 1,940 kg (4,277 lb)Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 2,900 kg (6,393 lb)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | Ahead (a fact, not an advantage)The Renault 70-32 PX is 49% heavier (960 kg / 2,116 lb) than the Fiat 70-66 F (DT/F) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 70-66 F (DT/F) and the 70-32 PX. |
| Which has the wider choice of gears? | 12 to 20Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 12 to 24Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 70-66 F (DT/F) and the 70-32 PX. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 540/1000 rpmTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | independentTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 70-66 F/70-66 F/DT” | 2WDTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131” | AheadThe Fiat 70-66 F (DT/F) is available with four-wheel drive; the Renault 70-32 PX is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1984–1991 | 1989–1992 | Ahead (a fact, not an advantage)The Renault 70-32 PX is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Renault 70-32 PX is 49% heavier (960 kg / 2,116 lb) than the Fiat 70-66 F (DT/F) (both unladen weight, as stated by the source).
- The Fiat 70-66 F (DT/F) is available with four-wheel drive; the Renault 70-32 PX is two-wheel drive (as stated by the sources).
- The Renault 70-32 PX is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Not comparable on three-point lift: the 70-66 F (DT/F): lift 610 mm behind the hitch ends, as stated by the source (Traktorenlexikon, “Fiat 70-66 F/70-66 F/DT”); the 70-32 PX: lift at the hitch ends, as stated by the source (Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources