9 material differences · fewer than 12
Tractor oneFiat 666 (DT)1982–1986No measured PTO figureTractor twoSAME Centauro 70 (DT)1981–1987No measured PTO figure
Which should you choose?
Read our verdict on the 666 (DT) and the Centauro 70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 666 (DT) | Centauro 70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 67 hp | 67 hp | — |
| Engine declared | FIAT-IVECO 8045.02.276 or 376 | SAME DA 984 P or DA 1004 P | differs |
| Displacement declared | 3.46 L | — | — |
| Maximum torque declared | 161 lb·ft · 218 N·m | 170 lb·ft · 230 N·m | +6% Centauro 70 (DT) |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5–18.6 mph · 25–30 km/h | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 11.2 gpm · 42.5 L/min | — |
| Three-point lift, at the coupling points declared | 6,923 lb · 3,140 kg | 8,157 lb · 3,700 kg | +18% Centauro 70 (DT) |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,688 lb · 2,580 kg | 6,019 lb · 2,730 kg | +6% Centauro 70 (DT) |
| Wheelbase declared | 90.7 in · 2,305 mm | 92.5 in · 2,350 mm | — |
| Length declared | 134.3 in · 3,412 mm | 151.2 in · 3,840 mm | +13% Centauro 70 (DT) |
| Width declared | 77.2 in · 1,960 mm | 76.0–95.7 in · 1,930–2,430 mm | differs |
| Ground clearance declared | 19.5 in · 495 mm | 16.5 in · 420 mm | +18% 666 (DT) |
| Turning radius, braked declared | 12.6 ft · 3.84 m | 11.5 ft · 3.50 m | +10% 666 (DT) |
| Fuel tank declared | 77.1 qt · 73.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 666 (DT) sources
- Source: Traktorenlexikon, “Fiat 666/666 DT”
SAME Centauro 70 (DT) sources
- Source: Traktorenlexikon, “SAME Centauro 70 (DT)”