Fiat 65-66 (DT) or Landini R-7880 (DT)?
Which should you choose?
On performance, every comparable figure that differs favours the Landini R-7880 (DT): hydraulic flow and three-point lift.
- The Landini R-7880 (DT) suits loader and hydraulic implement work better on this data: 12% (3.9 L/min / 1.0 gpm) more hydraulic flow and 32% (744 kg / 1,640 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 65-66 (DT) | R-7880 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 44.1 kW (59.1 hp)Traktorenlexikon, “Fiat 65-66/65-66 DT” | 44.3 kW (59.4 hp)Traktorenlexikon, “Landini 7880” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 65-66 (DT) and the R-7880 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 65-66 (DT) and the R-7880 (DT). |
| Which pumps more oil for implements? | 32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiat 65-66/65-66 DT” | 36.7 L/min (9.7 gpm)Traktorenlexikon, “Landini 7880” | AheadThe Landini R-7880 (DT) has 12% more hydraulic flow (3.9 L/min / 1.0 gpm) than the Fiat 65-66 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,356 kg (5,194 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | 3,100 kg (6,834 lb)Traktorenlexikon, “Landini 7880” | AheadThe Landini R-7880 (DT) has 32% more lift (744 kg / 1,640 lb) than the Fiat 65-66 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,510 kg (5,534 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | 3,340 kg (7,363 lb)Traktorenlexikon, “Landini 7880” | Ahead (a fact, not an advantage)The Landini R-7880 (DT) is 33% heavier (830 kg / 1,830 lb) than the Fiat 65-66 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 4,200 kg (9,259 lb)Traktorenlexikon, “Fiat 65-66/65-66 DT” | — | No figureNo call on maximum permissible mass: no figure on record for the R-7880 (DT). |
| Which has the wider choice of gears? | 12 to 20Traktorenlexikon, “Fiat 65-66/65-66 DT” | 12 to 24Traktorenlexikon, “Landini 7880” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 65-66 (DT) and the R-7880 (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiat 65-66/65-66 DT” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Landini 7880” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiat 65-66/65-66 DT” | 540/540E/1000 rpmTraktorenlexikon, “Landini 7880” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiat 65-66/65-66 DT” | — | No figureNo call on PTO independence: not stated for the R-7880 (DT). |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 65-66/65-66 DT” | Two-wheel or four-wheel driveTraktorenlexikon, “Landini 7880” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1985–1991 | 1987–2000 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Landini R-7880 (DT) has 12% more hydraulic flow (3.9 L/min / 1.0 gpm) than the Fiat 65-66 (DT) (both pump flow, as stated by the source).
- The Landini R-7880 (DT) has 32% more lift (744 kg / 1,640 lb) than the Fiat 65-66 (DT) (both lift at the hitch ends, as stated by the source).
- The Landini R-7880 (DT) is 33% heavier (830 kg / 1,830 lb) than the Fiat 65-66 (DT) (both unladen weight, as stated by the source).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources