12 material differences
Tractor oneFiat 65-56 LM (DT)from 1988No measured PTO figureTractor twoFord 4830 (A)1990–1992No measured PTO figure
Which should you choose?
Read our verdict on the 65-56 LM (DT) and the 4830 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 65-56 LM (DT) | 4830 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64.1 hp | 64.1 hp | — |
| Engine declared | Fiat 8045.06.220 or 320 | Ford L 256 CID-NA | differs |
| Displacement declared | 3.61 L | 4.19 L | +16% 4830 (A) |
| Maximum torque declared | 151 lb·ft · 205 N·m | 184 lb·ft · 250 N·m | +22% 4830 (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Dry LuK or VALEO double clutch | Pedal-operated dry AP single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 8.7 gpm · 32.8 L/min | 9.3 gpm · 35.3 L/min | +8% 4830 (A) |
| Pressure declared | 3,046 psi · 210 bar | 1,378–1,450 psi · 95–100 bar | differs |
| Three-point lift, at the coupling points declared | 3,847 lb · 1,745 kg | 4,381 lb · 1,987 kg | +14% 4830 (A) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,004 lb · 2,270 kg | 6,526 lb · 2,960 kg | +30% 4830 (A) |
| Wheelbase declared | 85.3 in · 2,167 mm | 89.6 in · 2,276 mm | — |
| Length declared | 141.7 in · 3,600 mm | 143.7 in · 3,650 mm | — |
| Width declared | 71.7–91.3 in · 1,820–2,320 mm | 69.7–96.7 in · 1,771–2,457 mm | differs |
| Ground clearance declared | 18.9 in · 480 mm | 12.0 in · 305 mm | +57% 65-56 LM (DT) |
| Turning radius, braked declared | 11.5 ft · 3.51 m | — | — |
| Fuel tank declared | 63.4 qt · 60.0 L | 69.4 qt · 65.7 L | +10% 4830 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 65-56 LM (DT) sources
Source
- Source: Traktorenlexikon, “Fiatagri 65-56 LM (DT)”
Ford 4830 (A) sources
Source
- Source: Traktorenlexikon, “Ford 4830”