10 material differences · fewer than 12
Tractor oneFiat 60-66 S (DT)1992–1996No measured PTO figureTractor twoRenault Ceres 70 X (A)1992–1995No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their power is identical, with the same weight or the same engine, which usually means one machine sold under two names; any difference below comes from how each source describes it. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 60-66 S (DT) | Ceres 70 X (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.3 hp | 59.3 hp | — |
| Engine declared | Fiat 8035.05 | MWM D 226-3 | differs |
| Displacement declared | 2.93 L | 3.12 L | +6% Ceres 70 X (A) |
| Maximum torque declared | 150 lb·ft · 203 N·m | 140 lb·ft · 190 N·m | +7% 60-66 S (DT) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Constant flow | — |
| Pump flow declared | 9.1 gpm · 34.5 L/min | 12.7 gpm · 48.0 L/min | +39% Ceres 70 X (A) |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Three-point lift, at the coupling points declared | 6,614 lb · 3,000 kg | 6,327 lb · 2,870 kg | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,107 lb · 2,770 kg | 6,184 lb · 2,805 kg | — |
| Maximum permissible mass declared | 9,259 lb · 4,200 kg | 11,398 lb · 5,170 kg | +23% Ceres 70 X (A) |
| Wheelbase declared | 85.8 in · 2,180 mm | 93.3 in · 2,369 mm | +9% Ceres 70 X (A) |
| Length declared | 143.3 in · 3,640 mm | 150.1 in · 3,812 mm | — |
| Width declared | 78.0–92.5 in · 1,980–2,350 mm | 73.2–92.3 in · 1,860–2,345 mm | differs |
| Ground clearance declared | 20.9 in · 530 mm | 17.7 in · 450 mm | +18% 60-66 S (DT) |
| Turning radius, braked declared | — | 12.5 ft · 3.80 m | — |
| Fuel tank declared | 77.1 qt · 73.0 L | 137.4 qt · 130.0 L | +78% Ceres 70 X (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 60-66 S (DT) sources
- Source: Traktorenlexikon, “Fiatagri 60-66S/60-66 DTS”
Renault Ceres 70 X (A) sources
- Source: Traktorenlexikon, “Renault Ceres 70X”
- Source: Traktorenlexikon, “Renault 551 R7451”