9 material differences · fewer than 12
Tractor oneFiat 55-90 (DT)1984–1992No measured PTO figureTractor twoSAME Condor 55 (DT)1982–1983No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (40%); they were not built in overlapping years (1984–1992; 1982–1983). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 55-90 (DT) | Condor 55 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 54.3 hp | 54.3 hp | — |
| Engine declared | FIAT-IVECO 8035.06.200 or (300) | SAME 983P | differs |
| Displacement declared | 2.71 L | 2.83 L | — |
| Maximum torque declared | 129 lb·ft · 175 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Dry Valeo, O.M.G. or LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.3 gpm · 24.0 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,129 lb · 2,780 kg | 4,365 lb · 1,980 kg | +40% 55-90 (DT) |
| Wheelbase declared | 87.7 in · 2,227 mm | 79.3 in · 2,015 mm | +11% 55-90 (DT) |
| Length declared | 147.0 in · 3,733 mm | 131.9 in · 3,350 mm | +11% 55-90 (DT) |
| Width declared | 67.3–90.9 in · 1,710–2,310 mm | 68.5–88.2 in · 1,740–2,240 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | 13.8 in · 350 mm | +27% 55-90 (DT) |
| Turning radius, braked declared | 11.4 ft · 3.46 m | 9.8 ft · 3.00 m | +15% 55-90 (DT) |
| Fuel tank declared | 98.3 qt · 93.0 L | 63.4 qt · 60.0 L | +55% 55-90 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 55-90 (DT) sources
- Source: Traktorenlexikon, “Fiatagri 55-90/55-90 DT”
SAME Condor 55 (DT) sources
- Source: Traktorenlexikon, “SAME Condor 55 (DT)”