12 material differences
Tractor oneFiat 55-66 S (DT)1992–1995No measured PTO figureTractor twoMassey Ferguson MF 352 (A)1993–1997No measured PTO figure
Which should you choose?
Read our verdict on the 55-66 S (DT) and the MF 352 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 55-66 S (DT) | MF 352 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 54.3 hp | 54.3 hp | — |
| Engine declared | FIAT-IVECO 8035.06 | Perkins AT 3.152-4 | differs |
| Displacement declared | 2.71 L | 2.50 L | +8% 55-66 S (DT) |
| Maximum torque declared | 130 lb·ft · 176 N·m | 133 lb·ft · 180 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Dry OMG or LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 9.1 gpm · 34.5 L/min | 15.1 gpm · 57.0 L/min | +65% MF 352 (A) |
| Pressure declared | 3,118 psi · 215 bar | 2,973–3,481 psi · 205–240 bar | differs |
| Three-point lift, at the coupling points declared | 6,614 lb · 3,000 kg | 4,729 lb · 2,145 kg | +40% 55-66 S (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,809 lb · 2,635 kg | 5,512 lb · 2,500 kg | +5% 55-66 S (DT) |
| Maximum permissible mass declared | 8,488 lb · 3,850 kg | — | — |
| Wheelbase declared | 78.7 in · 1,999 mm | 81.9 in · 2,080 mm | — |
| Length declared | 127.6 in · 3,241 mm | 141.9 in · 3,604 mm | +11% MF 352 (A) |
| Width declared | 60.6–84.3 in · 1,540–2,140 mm | 77.9 in · 1,979 mm | differs |
| Ground clearance declared | 18.1 in · 460 mm | 14.2 in · 360 mm | +28% 55-66 S (DT) |
| Fuel tank declared | 77.1 qt · 73.0 L | 71.9 qt · 68.0 L | +7% 55-66 S (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 55-66 S (DT) sources
Source
- Source: Traktorenlexikon, “Fiatagri 55-66S/55-66 DTS”
- Source: Traktorenlexikon, “Fiat 50-66/50-66 DT”
Massey Ferguson MF 352 (A) sources
Source
- Source: Traktorenlexikon, “Massey Ferguson MF 352”
- Source: Traktorenlexikon, “Massey Ferguson MF 253”