Fiat 55-56 LM (DT) or IMT 560?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Fiat 55-56 LM (DT) is ahead on forward gears and drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat 55-56 LM (DT) and IMT 560, with the call on each
Question55-56 LM (DT)560Call
Which puts more power through the PTO shaft?32.1 kW (43.0 hp)Traktorenlexikon, “Fiatagri 55-56 LM (DT)”32.2 kW (43.2 hp)Traktorenlexikon, “IMT 560”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 55-56 LM (DT) and the 560.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 55-56 LM (DT) and the 560.
Which pumps more oil for implements?32.8 L/min (8.7 gpm)Traktorenlexikon, “Fiatagri 55-56 LM (DT)”No figureNo call on hydraulic flow: no figure on record for the 560.
Which lifts more on the three-point hitch?1,745 kg (3,847 lb)Traktorenlexikon, “Fiatagri 55-56 LM (DT)”1,755 kg (3,869 lb)Traktorenlexikon, “IMT 560”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?2,140 kg (4,718 lb)Traktorenlexikon, “Fiatagri 55-56 LM (DT)”2,470 kg (5,445 lb)Traktorenlexikon, “IMT 560”Ahead (a fact, not an advantage)The IMT 560 is 15% heavier (330 kg / 728 lb) than the Fiat 55-56 LM (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 55-56 LM (DT) and the 560.
Which has the wider choice of gears?8 to 12Traktorenlexikon, “Fiatagri 55-56 LM (DT)”6Traktorenlexikon, “IMT 560”AheadThe Fiat 55-56 LM (DT) has 33% more forward gears (2 gears) than the IMT 560 (both forward gears, as stated by the source).
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 55-56 LM (DT) and the 560.
Which is faster on the road?25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Fiatagri 55-56 LM (DT)”30 km/h (18.6 mph)Traktorenlexikon, “IMT 560”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Fiatagri 55-56 LM (DT)”540 rpmTraktorenlexikon, “IMT 560”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?No figureNo call on PTO independence: not stated for the 55-56 LM (DT) and the 560.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 55-56 LM (DT)”2WDTraktorenlexikon, “IMT 560”AheadThe Fiat 55-56 LM (DT) is available with four-wheel drive; the IMT 560 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1988–1980–1986Ahead (a fact, not an advantage)The Fiat 55-56 LM (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The IMT 560 is 15% heavier (330 kg / 728 lb) than the Fiat 55-56 LM (DT) (both unladen weight, as stated by the source).
  • The Fiat 55-56 LM (DT) has 33% more forward gears (2 gears) than the IMT 560 (both forward gears, as stated by the source).
  • The Fiat 55-56 LM (DT) is available with four-wheel drive; the IMT 560 is two-wheel drive (as stated by the sources).
  • The Fiat 55-56 LM (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540 rpm).
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources