10 material differences · fewer than 12
Tractor oneFiat 480-8 (DT)1981–1982No measured PTO figureTractor twoHürlimann D-95 L/S1975–1977No measured PTO figure
Which should you choose?
Read our verdict on the 480-8 (DT) and the D-95 L/S → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 480-8 (DT) | D-95 L/S | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 44.4 hp | +7% 480-8 (DT) |
| Engine declared | FIAT-IVECO 8035.02.200 (300) | Hürlimann DS-95 | differs |
| Displacement declared | 2.59 L | 2.95 L | +14% D-95 L/S |
| Maximum torque declared | 112 lb·ft · 152 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.1 gpm · 26.8 L/min | 8.2 gpm · 31.0 L/min | +16% D-95 L/S |
| Pressure declared | 2,843 psi · 196 bar | 2,702 psi · 186 bar | +5% 480-8 (DT) |
| Three-point lift, at the coupling points declared | 3,858 lb · 1,750 kg | 3,748 lb · 1,700 kg | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,990 lb · 1,810 kg | 4,475 lb · 2,030 kg | +12% D-95 L/S |
| Wheelbase declared | 76.9 in · 1,953 mm | 74.8 in · 1,900 mm | — |
| Length declared | 114.6 in · 2,910 mm | 129.9 in · 3,300 mm | +13% D-95 L/S |
| Width declared | 70.5 in · 1,790 mm | 68.9 in · 1,750 mm | — |
| Ground clearance declared | 17.9 in · 455 mm | 14.4 in · 365 mm | +25% 480-8 (DT) |
| Turning radius, braked declared | 9.7 ft · 2.95 m | 8.4 ft · 2.55 m | +16% 480-8 (DT) |
| Fuel tank declared | 57.1 qt · 54.0 L | 42.3 qt · 40.0 L | +35% 480-8 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 480-8 (DT) sources
- Source: Traktorenlexikon, “Fiat 480-8/480-8 DT”
- Source: Traktorenlexikon, “Fiat 480/480 DT”
Hürlimann D-95 L/S sources
- Source: Traktorenlexikon, “Hürlimann D 95 L/S”
- Source: Traktorenlexikon, “Hürlimann D 110”