Fiat 466 (DT) or Leyland 255?

Which should you choose?

On performance, every comparable figure that differs favours the Fiat 466 (DT): three-point lift. It is also ahead on drive.

  • The Fiat 466 (DT) suits loader and hydraulic implement work better on this data: 39% (725 kg / 1,598 lb) more three-point lift.
  • The Fiat 466 (DT) suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat 466 (DT) and Leyland 255, with the call on each
Question466 (DT)255Call
Which puts more power through the PTO shaft?31.8 kW (42.6 hp)Traktorenlexikon, “Fiat 466/466 DT”31.8 kW (42.6 hp)Traktorenlexikon, “Leyland 255”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 466 (DT) and the 255.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 466 (DT) and the 255.
Which pumps more oil for implements?29.5 L/min (7.8 gpm)Traktorenlexikon, “Leyland 255”No figureNo call on hydraulic flow: no figure on record for the 466 (DT).
Which lifts more on the three-point hitch?2,600 kg (5,732 lb)Traktorenlexikon, “Fiat 466/466 DT”1,875 kg (4,134 lb)Traktorenlexikon, “Leyland 255”AheadThe Fiat 466 (DT) has 39% more lift (725 kg / 1,598 lb) than the Leyland 255 (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,280 kg (5,027 lb)Traktorenlexikon, “Fiat 466/466 DT”2,470 kg (5,445 lb)Traktorenlexikon, “Leyland 255”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 466 (DT) and the 255.
Which has the wider choice of gears?12 to 20Traktorenlexikon, “Fiat 466/466 DT”10Traktorenlexikon, “Leyland 255”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 466 (DT) and the 255.
Which is faster on the road?25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Fiat 466/466 DT”26 km/h (16.2 mph)Traktorenlexikon, “Leyland 255”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Fiat 466/466 DT”540 rpmTraktorenlexikon, “Leyland 255”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiat 466/466 DT”independentTraktorenlexikon, “Leyland 255”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 466/466 DT”2WDTraktorenlexikon, “Leyland 255”AheadThe Fiat 466 (DT) is available with four-wheel drive; the Leyland 255 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1982–19861973–1975Ahead (a fact, not an advantage)The Fiat 466 (DT) is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Fiat 466 (DT) has 39% more lift (725 kg / 1,598 lb) than the Leyland 255 (both lift at the hitch ends, as stated by the source).
  • The Fiat 466 (DT) is available with four-wheel drive; the Leyland 255 is two-wheel drive (as stated by the sources).
  • The Fiat 466 (DT) is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is independent.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources