11 material differences · fewer than 12
Tractor oneFiat 460 (DT)1980No measured PTO figureTractor twoSteyr 8060 (a)1979–1992No measured PTO figure
Which should you choose?
Read our verdict on the 460 (DT) and the 8060 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 460 (DT) | 8060 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | FIAT-IVECO 8035.01.300 | Steyr WD-311.41 or WD-311.87 | differs |
| Displacement declared | 2.34 L | 2.59 L | +11% 8060 (a) |
| Maximum torque declared | 110 lb·ft · 149 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry Fichtel & Sachs double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.1 gpm · 26.8 L/min | 6.4 gpm · 24.1 L/min | +11% 460 (DT) |
| Pressure declared | 2,843 psi · 196 bar | 3,553 psi · 245 bar | +25% 8060 (a) |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,990 lb · 1,810 kg | 5,335 lb · 2,420 kg | +34% 8060 (a) |
| Wheelbase declared | 76.9 in · 1,953 mm | 80.1 in · 2,035 mm | — |
| Length declared | 127.3 in · 3,233 mm | 137.6 in · 3,495 mm | +8% 8060 (a) |
| Width declared | 60.2–87.8 in · 1,530–2,230 mm | 67.3–90.2 in · 1,710–2,290 mm | differs |
| Ground clearance declared | 17.9 in · 455 mm | 14.2 in · 360 mm | +26% 460 (DT) |
| Turning radius, braked declared | 10.2 ft · 3.10 m | 10.6 ft · 3.24 m | — |
| Fuel tank declared | 57.1 qt · 54.0 L | 101.4 qt · 96.0 L | +78% 8060 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 460 (DT) sources
- Source: Traktorenlexikon, “Fiat 460/460 DT”
- Source: Traktorenlexikon, “Someca 450 N”
Steyr 8060 (a) sources
- Source: Traktorenlexikon, “Steyr 8060”