8 material differences · fewer than 12
Tractor oneFiat 440 (DT)1982No measured PTO figureTractor twoSOMECA 450 Special V/E1978–1982No measured PTO figure
Which should you choose?
Read our verdict on the 440 (DT) and the 450 Special V/E → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 9 fields identical or within 5%, which is not counted as material
| Field | 440 (DT) | 450 Special V/E | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.4 hp | 44.4 hp | — |
| Engine declared | FIAT-IVECO 8035.02 | FIAT-IVECO 8035.01.309 | differs |
| Displacement declared | 2.59 L | 2.34 L | +11% 440 (DT) |
| Maximum torque declared | 114 lb·ft · 154 N·m | 108 lb·ft · 146 N·m | +5% 440 (DT) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | dry FEREDO double clutch type 11/11" | Dry FEREDO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 7.1 gpm · 26.8 L/min | 6.2 gpm · 23.4 L/min | +15% 440 (DT) |
| Pressure declared | 2,843 psi · 196 bar | 2,843 psi · 196 bar | — |
| Three-point lift, at the coupling points declared | 3,858 lb · 1,750 kg | 3,307 lb · 1,500 kg | +17% 440 (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,189 lb · 1,900 kg | 3,858 lb · 1,750 kg | +9% 440 (DT) |
| Wheelbase declared | 76.8 in · 1,950 mm | 75.6 in · 1,920 mm | — |
| Length declared | 126.8 in · 3,220 mm | 122.8 in · 3,120 mm | — |
| Width declared | 65.0 in · 1,650 mm | 38.6–43.3 in · 980–1,100 mm | differs |
| Ground clearance declared | 13.8 in · 350 mm | 13.4 in · 340 mm | — |
| Turning radius, braked declared | 9.7 ft · 2.95 m | 9.4 ft · 2.85 m | — |
| Fuel tank declared | 57.1 qt · 54.0 L | 57.1 qt · 54.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 440 (DT) sources
- Source: Traktorenlexikon, “Fiat 440/440 DT”
- Source: Traktorenlexikon, “Someca 440”
SOMECA 450 Special V/E sources
- Source: Traktorenlexikon, “Someca 450 SE/SV”
- Source: Traktorenlexikon, “Someca 450 S”