8 material differences · fewer than 12
Tractor oneFiat 44-281979–1982No measured PTO figureTractor twoSchlüter Profi Trac 2500 TVL1985–1989No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1979–1982; 1985–1989). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 44-28 | Profi Trac 2500 TVL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 276.4 hp | 279.7 hp | — |
| Engine declared | CUMMINS NT-855 C 280 | MAN D 2566 MTE | differs |
| Displacement declared | 14.02 L | 11.41 L | +23% 44-28 |
| Maximum torque declared | 863 lb·ft · 1,170 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 21.4 mph · 34.5 km/h | +38% Profi Trac 2500 TVL |
| Clutch declared | Dry Dana-Spicer double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 23.6 gpm · 89.4 L/min | 10.6 gpm · 40.1 L/min | +123% 44-28 |
| Pressure declared | 3,336–3,481 psi · 230–240 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 22,972 lb · 10,420 kg | 24,637 lb · 11,175 kg | +7% Profi Trac 2500 TVL |
| Wheelbase declared | 131.5 in · 3,340 mm | 116.1 in · 2,950 mm | +13% 44-28 |
| Length declared | 255.9 in · 6,500 mm | 240.2 in · 6,100 mm | +7% 44-28 |
| Width declared | 99.6 in · 2,530 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 16.5 in · 420 mm | 16.1 in · 410 mm | — |
| Turning radius, braked declared | — | 16.4 ft · 5.00 m | — |
| Fuel tank declared | 739.7 qt · 700.0 L | 470.2 qt · 445 L | +57% 44-28 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 44-28 sources
- Source: Traktorenlexikon, “Fiat Fiat 44-28”
Schlüter Profi Trac 2500 TVL sources
- Source: Traktorenlexikon, “Schlüter Profi Trac 2500 TVL”
- Source: Traktorenlexikon, “Fendt Favorit 626 LS/LSA”