Fiat 420 (DT) or Renault 421 M?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 420 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 421 M has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat 420 (DT) and Renault 421 M, with the call on each
Question420 (DT)421 MCall
Which puts more power through the PTO shaft?30.9 kW (41.4 hp)Traktorenlexikon, “Fiat 420/420 DT”30.9 kW (41.4 hp)Traktorenlexikon, “Renault 421 M / R 7421”Not comparableNot comparable on power at the PTO shaft: the 420 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 421 M has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 420 (DT) and the 421 M.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 420 (DT) and the 421 M.
Which pumps more oil for implements?—25.9 L/min (6.8 gpm)Traktorenlexikon, “Renault 421 M / R 7421”No figureNo call on hydraulic flow: no figure on record for the 420 (DT).
Which lifts more on the three-point hitch?1,080 kg (2,381 lb)Traktorenlexikon, “Fiat 420/420 DT”—No figureNo call on three-point lift: no figure on record for the 421 M.
Which is heavier, for traction?1,650 kg (3,638 lb)Traktorenlexikon, “Fiat 420/420 DT”1,995 kg (4,398 lb)Traktorenlexikon, “Renault 421 M / R 7421”Ahead (a fact, not an advantage)The Renault 421M is 21% heavier (345 kg / 761 lb) than the Fiat 420 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 420 (DT) and the 421 M.
Which has the wider choice of gears?6 to 9Traktorenlexikon, “Fiat 420/420 DT”10Traktorenlexikon, “Renault 421 M / R 7421”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?—YesTraktorenlexikon, “Renault 421 M / R 7421”No figureNo call on a creeper range: not stated for the 420 (DT).
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Fiat 420/420 DT”25 km/h (15.5 mph)Traktorenlexikon, “Renault 421 M / R 7421”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Fiat 420/420 DT”540 rpmTraktorenlexikon, “Renault 421 M / R 7421”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiat 420/420 DT”independentTraktorenlexikon, “Renault 421 M / R 7421”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 420/420 DT”2WDTraktorenlexikon, “Renault 421 M / R 7421”AheadThe Fiat 420 (DT) is available with four-wheel drive; the Renault 421M is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1978–19851977–1985EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Renault 421M is 21% heavier (345 kg / 761 lb) than the Fiat 420 (DT) (both unladen weight, as stated by the source).
  • The Fiat 420 (DT) is available with four-wheel drive; the Renault 421M is two-wheel drive (as stated by the sources).
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is independent.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 420 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 421 M has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources