Fiat 400 V/E or SAME Delfino 35 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 400 V/E has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Delfino 35 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 400 V/E | Delfino 35 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 25 kW (34 hp)Traktorenlexikon, “Fiat 400 V/E” | 25 kW (34 hp)Traktorenlexikon, “SAME Delfino 35” | Not comparableNot comparable on power at the PTO shaft: the 400 V/E has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Delfino 35 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 400 V/E and the Delfino 35 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 400 V/E and the Delfino 35 (DT). |
| Which pumps more oil for implements? | 21.8 L/min (5.8 gpm)Traktorenlexikon, “Fiat 400 V/E” | 13.0 L/min (3.4 gpm)Traktorenlexikon, “SAME Delfino 35” | AheadThe Fiat 400 V/E has 68% more hydraulic flow (8.8 L/min / 2.3 gpm) than the SAME Delfino 35 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,300 kg (2,866 lb)Traktorenlexikon, “Fiat 400 V/E” | 1,550 kg (3,417 lb)Traktorenlexikon, “SAME Delfino 35” | AheadThe SAME Delfino 35 (DT) has 19% more lift (250 kg / 551 lb) than the Fiat 400 V/E (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 1,610 kg (3,549 lb)Traktorenlexikon, “Fiat 400 V/E” | 1,400 kg (3,086 lb)Traktorenlexikon, “SAME Delfino 35” | Ahead (a fact, not an advantage)The Fiat 400 V/E is 15% heavier (210 kg / 463 lb) than the SAME Delfino 35 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 400 V/E and the Delfino 35 (DT). |
| Which has the wider choice of gears? | 6 to 9Traktorenlexikon, “Fiat 400 V/E” | 6 to 12Traktorenlexikon, “SAME Delfino 35” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 400 V/E and the Delfino 35 (DT). |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Fiat 400 V/E” | 25 km/h (15.5 mph)Traktorenlexikon, “SAME Delfino 35” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Fiat 400 V/E” | 540 rpmTraktorenlexikon, “SAME Delfino 35” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Fiat 400 V/E” | independentTraktorenlexikon, “SAME Delfino 35” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Fiat 400 V/E” | Two-wheel or four-wheel driveTraktorenlexikon, “SAME Delfino 35” | AheadThe SAME Delfino 35 (DT) is available with four-wheel drive; the Fiat 400 V/E is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1968–1971 | 1972–1981 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fiat 400 V/E has 68% more hydraulic flow (8.8 L/min / 2.3 gpm) than the SAME Delfino 35 (DT) (both pump flow, as stated by the source).
- The SAME Delfino 35 (DT) has 19% more lift (250 kg / 551 lb) than the Fiat 400 V/E (both lift at the hitch ends, as stated by the source).
- The Fiat 400 V/E is 15% heavier (210 kg / 463 lb) than the SAME Delfino 35 (DT) (both unladen weight, as stated by the source).
- The SAME Delfino 35 (DT) is available with four-wheel drive; the Fiat 400 V/E is two-wheel drive (as stated by the sources).
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540 rpm).
- Even on PTO independence: every PTO is independent.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 400 V/E has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Delfino 35 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources