Fiat 35-66 (DT) or URSUS 2812?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 35-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2812 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The URSUS 2812 suits loader and hydraulic implement work better on this data: 22% (244 kg / 538 lb) more three-point lift.
  • The Fiat 35-66 (DT) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat 35-66 (DT) and URSUS 2812, with the call on each
Question35-66 (DT)2812Call
Which puts more power through the PTO shaft?25.8 kW (34.6 hp)Traktorenlexikon, “Fiat 35-66/35-66 DT”27.9 kW (37.4 hp)Traktorenlexikon, “Ursus 2812”Not comparableNot comparable on power at the PTO shaft: the 35-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2812 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 35-66 (DT) and the 2812.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 35-66 (DT) and the 2812.
Which pumps more oil for implements?18.8 L/min (5.0 gpm)Traktorenlexikon, “Ursus 2812”No figureNo call on hydraulic flow: no figure on record for the 35-66 (DT).
Which lifts more on the three-point hitch?1,122 kg (2,474 lb)Traktorenlexikon, “Fiat 35-66/35-66 DT”1,366 kg (3,012 lb)Traktorenlexikon, “Ursus 2812”AheadThe URSUS 2812 has 22% more lift (244 kg / 538 lb) than the Fiat 35-66 (DT) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?1,310 kg (2,888 lb)Traktorenlexikon, “Fiat 35-66/35-66 DT”2,020 kg (4,453 lb)Traktorenlexikon, “Ursus 2812”Ahead (a fact, not an advantage)The URSUS 2812 is 54% heavier (710 kg / 1,565 lb) than the Fiat 35-66 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 35-66 (DT) and the 2812.
Which has the wider choice of gears?16Traktorenlexikon, “Fiat 35-66/35-66 DT”8Traktorenlexikon, “Ursus 2812”AheadThe Fiat 35-66 (DT) has 100% more forward gears (8 gears) than the URSUS 2812 (both forward gears, as stated by the source).
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 35-66 (DT) and the 2812.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Fiat 35-66/35-66 DT”25 km/h (15.5 mph)Traktorenlexikon, “Ursus 2812”AheadThe Fiat 35-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the URSUS 2812 (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Fiat 35-66/35-66 DT”540 rpmTraktorenlexikon, “Ursus 2812”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiat 35-66/35-66 DT”No figureNo call on PTO independence: not stated for the 2812.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 35-66/35-66 DT”2WDTraktorenlexikon, “Ursus 2812”AheadThe Fiat 35-66 (DT) is available with four-wheel drive; the URSUS 2812 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1990–19981988–2009EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The URSUS 2812 has 22% more lift (244 kg / 538 lb) than the Fiat 35-66 (DT) (both lift at the hitch ends, as stated by the source).
  • The URSUS 2812 is 54% heavier (710 kg / 1,565 lb) than the Fiat 35-66 (DT) (both unladen weight, as stated by the source).
  • The Fiat 35-66 (DT) has 100% more forward gears (8 gears) than the URSUS 2812 (both forward gears, as stated by the source).
  • The Fiat 35-66 (DT) has 20% more top speed (5.0 km/h / 3.1 mph) than the URSUS 2812 (both top speed forward, as stated by the source).
  • The Fiat 35-66 (DT) is available with four-wheel drive; the URSUS 2812 is two-wheel drive (as stated by the sources).
  • Even on PTO speeds: the same speeds (540 rpm).
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 35-66 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2812 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources