8 material differences · fewer than 12
Tractor oneFiat 35-66 (DT)1990–1998No measured PTO figureTractor twoHürlimann Prince 335 DT1995–1999No measured PTO figure
Which should you choose?
Read our verdict on the 35-66 (DT) and the Prince 335 DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 35-66 (DT) | Prince 335 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.6 hp | 34.6 hp | — |
| Engine declared | LOMBARDINI LDW-1503/B2 | SLH 500.3 A | differs |
| Displacement declared | 1.55 L | 1.57 L | — |
| Maximum torque declared | 67 lb·ft · 90.9 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Dry Valeo or LuK double clutch, type 9/9" | pedal-operated dry single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 2.1 gpm · 8.0 L/min | — |
| Pressure declared | 2,872 psi · 198 bar | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,888 lb · 1,310 kg | 2,447 lb · 1,110 kg | +18% 35-66 (DT) |
| Wheelbase declared | 66.9 in · 1,700 mm | 64.2 in · 1,630 mm | — |
| Length declared | 114.6 in · 2,910 mm | 105.9 in · 2,690 mm | +8% 35-66 (DT) |
| Width declared | 54.3–74.0 in · 1,380–1,880 mm | 40.2–53.5 in · 1,020–1,360 mm | differs |
| Ground clearance declared | 14.6 in · 370 mm | 14.2 in · 360 mm | — |
| Turning radius, braked declared | 8.4 ft · 2.56 m | 9.3 ft · 2.82 m | +10% Prince 335 DT |
| Fuel tank declared | 37.0 qt · 35.0 L | 30.6 qt · 29.0 L | +21% 35-66 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 35-66 (DT) sources
- Source: Traktorenlexikon, “Fiat 35-66/35-66 DT”
Hürlimann Prince 335 DT sources
- Source: Traktorenlexikon, “Hürlimann Prince 335”