8 material differences · fewer than 12
Tractor oneFiat 211 R (A)1958–1964No measured PTO figureTractor twoJohn Deere Modell-M1947–1952No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (95%); the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1958–1964; 1947–1952). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 211 R (A) | Modell-M | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19.7 hp | 20.4 hp | — |
| Engine declared | FIAT 614.010 | — | — |
| Displacement declared | 1.14 L | — | — |
| Maximum torque declared | 49 lb·ft · 66.0 N·m | — | — |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 9.9 mph · 16 km/h | +38% 211 R (A) |
| Clutch declared | Pedal-operated dry single-plate clutch | Pedal-operated dry Auburn single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 2.0 gpm · 7.5 L/min | 4.3 gpm · 16.1 L/min | +115% Modell-M |
| Rear PTO speeds declared | 540 rpm | 546 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,017 lb · 915 kg | 3,929–4,292 lb · 1,782–1,947 kg | differs |
| Wheelbase declared | 66.9 in · 1,699 mm | 70.0 in · 1,778 mm | — |
| Length declared | 102.4 in · 2,601 mm | 102.0–125.2 in · 2,591–3,180 mm | differs |
| Width declared | 47.4–75.2 in · 1,203–1,911 mm | 50.8–89.4 in · 1,290–2,270 mm | differs |
| Ground clearance declared | 17.9 in · 455 mm | 21.0 in · 533 mm | +17% Modell-M |
| Turning radius, braked declared | 9.0 ft · 2.75 m | — | — |
| Fuel tank declared | 41.2 qt · 39.0 L | 40.0 qt · 37.9 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 211 R (A) sources
- Source: Traktorenlexikon, “Fiat 211 R/241 R”
John Deere Modell-M sources
- Source: Traktorenlexikon, “John Deere Modell M”