Fiat 180-90 (DT) or International Harvester 1586?
Which should you choose?
On performance, every comparable figure that differs favours the Fiat 180-90 (DT): hydraulic flow and three-point lift. It is also ahead on forward gears.
- The Fiat 180-90 (DT) suits loader and hydraulic implement work better on this data: 12% (5.4 L/min / 1.4 gpm) more hydraulic flow and 106% (3,390 kg / 7,474 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 180-90 (DT) | 1586 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 115.5 kW (154.9 hp)Traktorenlexikon, “Fiatagri 180-90 DT” | 116.4 kW (156.1 hp)Traktorenlexikon, “IHC 1586” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 180-90 (DT) and the 1586. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 180-90 (DT) and the 1586. |
| Which pumps more oil for implements? | 50.8 L/min (13.4 gpm)Traktorenlexikon, “Fiatagri 180-90 DT” | 45.4 L/min (12.0 gpm)Traktorenlexikon, “IHC 1586” | AheadThe Fiat 180-90 (DT) has 12% more hydraulic flow (5.4 L/min / 1.4 gpm) than the International Harvester 1586 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 6,600 kg (14,551 lb)Traktorenlexikon, “Fiatagri 180-90 DT” | 3,210 kg (7,077 lb)Traktorenlexikon, “IHC 1586” | AheadThe Fiat 180-90 (DT) has 106% more lift (3,390 kg / 7,474 lb) than the International Harvester 1586 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 6,330 kg (13,955 lb)Traktorenlexikon, “Fiatagri 180-90 DT” | 6,858 kg (15,119 lb)Traktorenlexikon, “IHC 1586” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 10,000 kg (22,046 lb)Traktorenlexikon, “Fiatagri 180-90 DT” | — | No figureNo call on maximum permissible mass: no figure on record for the 1586. |
| Which has the wider choice of gears? | 16 to 24Traktorenlexikon, “Fiatagri 180-90 DT” | 6 to 12Traktorenlexikon, “IHC 1586” | AheadThe Fiat 180-90 (DT) has 33% more forward gears (4 gears) than the International Harvester 1586 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 180-90 (DT) and the 1586. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri 180-90 DT” | 30 km/h (18.6 mph)Traktorenlexikon, “IHC 1586” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Fiatagri 180-90 DT” | 1000 rpmTraktorenlexikon, “IHC 1586” | EvenEven on PTO speeds: the same speeds (1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the 180-90 (DT) and the 1586. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri 180-90 DT” | Two-wheel or four-wheel driveTraktorenlexikon, “IHC 1586” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1984–1994 | 1976–1981 | Ahead (a fact, not an advantage)The Fiat 180-90 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fiat 180-90 (DT) has 12% more hydraulic flow (5.4 L/min / 1.4 gpm) than the International Harvester 1586 (both pump flow, as stated by the source).
- The Fiat 180-90 (DT) has 106% more lift (3,390 kg / 7,474 lb) than the International Harvester 1586 (both lift at the hitch ends, as stated by the source).
- The Fiat 180-90 (DT) has 33% more forward gears (4 gears) than the International Harvester 1586 (both forward gears, as stated by the source).
- The Fiat 180-90 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources