8 material differences · fewer than 12
Tractor oneFiat 1180 (DT)1979–1984No measured PTO figureTractor twoSAME Drago 120 (DT)1978–1986No measured PTO figure
Which should you choose?
Read our verdict on the 1180 (DT) and the Drago 120 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 1180 (DT) | Drago 120 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 113.5 hp | 113.3 hp | — |
| Engine declared | FIAT-IVECO 8065.04.217 (317) | SAME DA 1056 P | differs |
| Displacement declared | 5.50 L | 6.23 L | +13% Drago 120 (DT) |
| Maximum torque declared | 288 lb·ft · 390 N·m | 274 lb·ft · 372 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–18.6 mph · 25–30 km/h | 15.5 mph · 25 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 9.2 gpm · 35.0 L/min | — |
| Pressure declared | 3,336–3,481 psi · 230–240 bar | — | — |
| Three-point lift, at the coupling points declared | 10,384 lb · 4,710 kg | 9,348 lb · 4,240 kg | +11% 1180 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 10,115 lb · 4,588 kg | 9,149 lb · 4,150 kg | +11% 1180 (DT) |
| Wheelbase declared | 108.3 in · 2,750 mm | 104.7 in · 2,660 mm | — |
| Length declared | 161.2 in · 4,095 mm | 167.3 in · 4,250 mm | — |
| Width declared | 77.2–106.3 in · 1,960–2,700 mm | 89.4–109.6 in · 2,270–2,785 mm | differs |
| Ground clearance declared | 26.0 in · 660 mm | 22.8 in · 580 mm | +14% 1180 (DT) |
| Turning radius, braked declared | 12.7 ft · 3.88 m | 13.1 ft · 4.00 m | — |
| Fuel tank declared | 190.2 qt · 180.0 L | 95.1 qt · 90.0 L | +100% 1180 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 1180 (DT) sources
- Source: Traktorenlexikon, “Fiat 1180 DT”
SAME Drago 120 (DT) sources
- Source: Traktorenlexikon, “SAME Drago 120”