12 material differences
Tractor oneFiat 1000 (DT)1972–1976No measured PTO figureTractor twoJohn Deere 3350 (A)1986–1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1972–1976; 1986–1993). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 1000 (DT) | 3350 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.7 hp | 98.7 hp | — |
| Engine declared | FIAT-IVECO 8065.02.007 | John Deere 6.359 DL-009 | differs |
| Displacement declared | 5.18 L | 5.88 L | +13% 3350 (A) |
| Maximum torque declared | 226 lb·ft · 306 N·m | 292 lb·ft · 396 N·m | +29% 3350 (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Dry FERODO double clutch with separate PTO control | Pedal-operated dry LuK single-plate clutch as drive clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 12.3 gpm · 46.5 L/min | 13.8 gpm · 52.3 L/min | +12% 3350 (A) |
| Pressure declared | 2,901 psi · 200 bar | 3,336 psi · 230 bar | +15% 3350 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,771 lb · 3,525 kg | 9,315 lb · 4,225 kg | +20% 3350 (A) |
| Maximum permissible mass declared | — | 14,771 lb · 6,700 kg | — |
| Wheelbase declared | 97.6 in · 2,480 mm | 100.4 in · 2,551 mm | — |
| Length declared | 164.6 in · 4,180 mm | 175.8 in · 4,465 mm | +7% 3350 (A) |
| Width declared | 79.1–98.8 in · 2,010–2,510 mm | 88.5 in · 2,249 mm | differs |
| Ground clearance declared | 22.8 in · 580 mm | 25.6 in · 650 mm | +12% 3350 (A) |
| Turning radius, braked declared | 12.5 ft · 3.81 m | — | — |
| Fuel tank declared | 124.7 qt · 118.0 L | 127.9–182.8 qt · 121.0–173.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 1000 (DT) sources
- Source: Traktorenlexikon, “Fiat 1000/1000 DT”
John Deere 3350 (A) sources
- Source: Traktorenlexikon, “John Deere 3350”