Fendt Fix 2 D or John Deere-LANZ 100?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the Fix 2 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The Fendt Fix 2 D suits loader and hydraulic implement work better on this data: 57% (4.0 L/min / 1.1 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | Fix 2 D | 100 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 12.5 kW (16.8 hp)Traktorenlexikon, “Fendt Fix 2 D” | 13.2 kW (17.7 hp)Traktorenlexikon, “John Deere-Lanz 100” | Not comparableNot comparable on power at the PTO shaft: the Fix 2 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the Fix 2 D and the 100. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the Fix 2 D and the 100. |
| Which pumps more oil for implements? | 11.0 L/min (2.9 gpm)Traktorenlexikon, “Fendt Fix 2 D” | 7.0 L/min (1.8 gpm)Traktorenlexikon, “John Deere-Lanz 100” | AheadThe Fendt Fix 2 D has 57% more hydraulic flow (4.0 L/min / 1.1 gpm) than the John Deere-LANZ 100 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,200 kg (2,646 lb)Traktorenlexikon, “Fendt Fix 2 D” | — | No figureNo call on three-point lift: no figure on record for the 100. |
| Which is heavier, for traction? | 1,265 kg (2,789 lb)Traktorenlexikon, “Fendt Fix 2 D” | 1,230 kg (2,712 lb)Traktorenlexikon, “John Deere-Lanz 100” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | 2,000 kg (4,409 lb)Traktorenlexikon, “John Deere-Lanz 100” | No figureNo call on maximum permissible mass: no figure on record for the Fix 2 D. |
| Which has the wider choice of gears? | 6Traktorenlexikon, “Fendt Fix 2 D” | 6Traktorenlexikon, “John Deere-Lanz 100” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | YesTraktorenlexikon, “Fendt Fix 2 D” | — | No figureNo call on a creeper range: not stated for the 100. |
| Which is faster on the road? | 20 km/h (12.4 mph)Traktorenlexikon, “Fendt Fix 2 D” | 20 km/h (12.4 mph)Traktorenlexikon, “John Deere-Lanz 100” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 570 rpmTraktorenlexikon, “Fendt Fix 2 D” | 540/1000 rpmTraktorenlexikon, “John Deere-Lanz 100” | No figureNo call on PTO speeds: no standard PTO speed stated for the Fix 2 D. |
| Which PTO runs independently of the ground drive? | dependent (stops with the clutch)Traktorenlexikon, “Fendt Fix 2 D” | — | No figureNo call on PTO independence: not stated for the 100. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Fendt Fix 2 D” | 2WDTraktorenlexikon, “John Deere-Lanz 100” | EvenEven on drive: all two-wheel drive. |
| Which is newer, and what about parts? | 1963–1967 | 1962–1966 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Fendt Fix 2 D has 57% more hydraulic flow (4.0 L/min / 1.1 gpm) than the John Deere-LANZ 100 (both pump flow, as stated by the source).
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on drive: all two-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the Fix 2 D has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 100 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.
← Every figure for both machines, side by side, with sources