10 material differences · fewer than 12

Tractor oneFendt Favorit 8181993–2002No measured PTO figureTractor twoJohn Deere 4760 (A)1992–1994No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 2 fields identical or within 5%, which is not counted as material

Fendt Favorit 818 and John Deere 4760 (A), field by field
FieldFavorit 8184760 (A)Gap
Engine
Engine power, claimed claimed188 hp187.5 hp—
Engine declaredMAN D 0826 LE 521John Deere 6.076 TRW-07differs
Displacement declared6.87 L7.63 L+11% 4760 (A)
Maximum torque declared596 lb·ft · 808 N·m——
Transmission
Top speed declared24.9–31.1 mph · 40–50 km/h18.6 mph · 30 km/hdiffers
Clutch declaredWet multi-plate clutch as driving clutchPedal-operated, hydraulic and oil-cooled multi-plate clutchdiffers
Hydraulics & hitch
Hydraulic centre declared—Closed centre—
Hydraulic control declaredLoad sensing——
Pump flow declared26.9 gpm · 102.0 L/min——
Pressure declared2,901 psi · 200 bar——
Rear PTO speeds declared750/1000 rpm1000 rpmdiffers
Weight & dimensions
Unladen weight declared16,932 lb · 7,680 kg16,030 lb · 7,271 kg+6% Favorit 818
Maximum permissible mass declared26,455 lb · 12,000 kg——
Wheelbase declared111.8 in · 2,840 mm118.5 in · 3,010 mm+6% 4760 (A)
Length declared194.5 in · 4,940 mm213.4 in · 5,420 mm+10% 4760 (A)
Width declared100.4 in · 2,550 mm118.0 in · 2,997 mm+18% 4760 (A)
Ground clearance declared23.8 in · 605 mm17.9 in · 455 mm+33% Favorit 818
Turning radius, braked declared17.7 ft · 5.40 m——
Fuel tank declared391.0 qt · 370 L407.9 qt · 386.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Fendt Favorit 818 sources

Source
  • Source: Traktorenlexikon, “Fendt Favorit 818”

John Deere 4760 (A) sources

Source
  • Source: Traktorenlexikon, “John Deere 4760”
  • Source: Traktorenlexikon, “John Deere 4560”