6 material differences · fewer than 12
Tractor oneFendt Favorit 3s1967–1970No measured PTO figureTractor twoInternational Harvester 6841977–1981No measured PTO figure
Which should you choose?
Read our verdict on the Favorit 3s and the 684 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Favorit 3s | 684 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.9 hp | 68.0 hp | +12% 684 |
| Engine declared | MWM D 225.4 | INTERNATIONAL-HARVESTER D-239 | differs |
| Displacement declared | 3.38 L | 3.91 L | +16% 684 |
| Maximum torque declared | 157 lb·ft · 213 N·m | 162 lb·ft · 220 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Favorit 3s |
| Clutch declared | Tornado duplex clutch by Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 9.9 gpm · 37.5 L/min | — |
| Pressure declared | — | 2,698 psi · 186 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,986 lb · 2,715 kg | 5,181 lb · 2,350 kg | +16% Favorit 3s |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 89.0 in · 2,261 mm | 88.0 in · 2,235 mm | — |
| Length declared | 151.4 in · 3,845 mm | 146.5 in · 3,720 mm | — |
| Width declared | 73.5 in · 1,868 mm | 70.1 in · 1,780 mm | — |
| Ground clearance declared | 16.5 in · 420 mm | 14.6 in · 370 mm | +14% Favorit 3s |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 10.9 ft · 3.33 m | +11% Favorit 3s |
| Fuel tank declared | — | 81.4 qt · 77.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Favorit 3s sources
- Source: Traktorenlexikon, “Fendt Favorit 3 S/SA”
International Harvester 684 sources
- Source: Traktorenlexikon, “IHC 684”
- Source: Traktorenlexikon, “IHC 574”