10 material differences · fewer than 12
Tractor oneFendt Favorit 3s1967–1970No measured PTO figureTractor twoInternational Harvester 6741973–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1967–1970; 1973–1975). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Favorit 3s | 674 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 60.9 hp | 64.1 hp | +5% 674 |
| Engine declared | MWM D 225.4 | INTERNATIONAL-HARVESTER D-239 | differs |
| Displacement declared | 3.38 L | 3.91 L | +16% 674 |
| Maximum torque declared | 157 lb·ft · 213 N·m | 153 lb·ft · 207 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Tornado duplex clutch by Fichtel & Sachs | Pedal-operated dry LAYCOCK single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 11.1–12.6 gpm · 42.1–47.7 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,986 lb · 2,715 kg | 5,106 lb · 2,316 kg | +17% Favorit 3s |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | 89.0 in · 2,261 mm | 84.5 in · 2,146 mm | +5% Favorit 3s |
| Length declared | 151.4 in · 3,845 mm | 140.6 in · 3,570 mm | +8% Favorit 3s |
| Width declared | 73.5 in · 1,868 mm | 68.9 in · 1,750 mm | +7% Favorit 3s |
| Ground clearance declared | 16.5 in · 420 mm | 14.4 in · 365 mm | +15% Favorit 3s |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 10.9 ft · 3.31 m | +12% Favorit 3s |
| Fuel tank declared | — | 81.2 qt · 76.8 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Favorit 3s sources
- Source: Traktorenlexikon, “Fendt Favorit 3 S/SA”
International Harvester 674 sources
- Source: Traktorenlexikon, “IHC 674”
- Source: Traktorenlexikon, “IHC 574”
- Source: Traktorenlexikon, “IHC 674 (USA)”