9 material differences · fewer than 12
Tractor oneFendt Farmer 275 S/SA1988–1996No measured PTO figureTractor twoMassey Ferguson MF 2851975–1982No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1988–1996; 1975–1982). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Farmer 275 S/SA | MF 285 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 71 hp | — |
| Engine declared | KHD F4L 913 | Perkins A 4.248 | differs |
| Displacement declared | 4.09 L | 4.07 L | — |
| Maximum torque declared | 195 lb·ft · 265 N·m | 205 lb·ft · 278 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | dry double clutch from Fichtel & Sachs | Pedal operated, dry and air-cooled single clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 10.9 gpm · 41.1 L/min | 7.0 gpm · 26.5 L/min | +55% Farmer 275 S/SA |
| Pressure declared | 2,408 psi · 166 bar | — | — |
| Rear PTO speeds declared | 540/750 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,908 lb · 2,680 kg | 6,239 lb · 2,830 kg | +6% MF 285 |
| Wheelbase declared | 85.8 in · 2,180 mm | 90.0 in · 2,286 mm | — |
| Length declared | 143.5 in · 3,646 mm | 153.5 in · 3,900 mm | +7% MF 285 |
| Width declared | 74.0 in · 1,880 mm | 73.2 in · 1,860 mm | — |
| Ground clearance declared | 14.9 in · 378 mm | 18.5 in · 470 mm | +24% MF 285 |
| Turning radius, braked declared | — | 12.2 ft · 3.71 m | — |
| Fuel tank declared | 63.4 qt · 60 L | 95.1 qt · 90 L | +50% MF 285 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt Farmer 275 S/SA sources
- Source: Traktorenlexikon, “Fendt Farmer 275 S/SA”
- Source: Traktorenlexikon, “Deutz-Fahr DX 3.90”
Massey Ferguson MF 285 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 285”
- Source: Traktorenlexikon, “Massey Ferguson MF 178”