11 material differences · fewer than 12
Tractor oneFendt 828 Variofrom 2010No measured PTO figureTractor twoNew Holland T 80302006–2011No measured PTO figure
Which should you choose?
Read our verdict on the 828 Vario and the T 8030 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 828 Vario | T 8030 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 275 hp | 269.3 hp | — |
| Engine declared | Deutz TCD 2012 L06 4V | CUMMINS 6 TAA-8304 (TIER-III) | differs |
| Displacement declared | 6.06 L | 8.27 L | +37% T 8030 |
| Maximum torque declared | 892 lb·ft · 1,210 N·m | 861 lb·ft · 1,167 N·m | — |
| Transmission | |||
| Top speed declared | 37.3 mph · 60 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Multi-plate clutch | Electro-hydraulically operated wet multi-disc clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 40.2 gpm · 152 L/min | 44.0 gpm · 166.6 L/min | +10% T 8030 |
| Pressure declared | 2,901 psi · 200 bar | 3,336 psi · 230 bar | +15% T 8030 |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 20,834 lb · 9,450 kg | 21,711 lb · 9,848 kg | — |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 114.2 in · 2,900 mm | 121.2 in · 3,078 mm | +6% T 8030 |
| Length declared | 207.6 in · 5,274 mm | 229.5 in · 5,829 mm | +11% T 8030 |
| Width declared | 103.1 in · 2,620 mm | 98.0 in · 2,490 mm | — |
| Ground clearance declared | 22.3 in · 567 mm | 14.6 in · 372 mm | +52% 828 Vario |
| Fuel tank declared | 533.6 qt · 505 L | 720.7 qt · 682.0 L | +35% T 8030 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt 828 Vario sources
- Source: Traktorenlexikon, “Fendt 828 Vario”
New Holland T 8030 sources
- Source: Traktorenlexikon, “New Holland T8030”
- Source: Traktorenlexikon, “New Holland T8040”