10 material differences · fewer than 12
Tractor oneFendt 828 Variofrom 2010No measured PTO figureTractor twoJohn Deere 83302006–2009No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (2010–2010; 2006–2009). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 828 Vario | 8330 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 275 hp | 266.5 hp | — |
| Engine declared | Deutz TCD 2012 L06 4V | John Deere PowerTech-Plus 6.090 HRW-02 | differs |
| Displacement declared | 6.06 L | 8.98 L | +48% 8330 |
| Maximum torque declared | 892 lb·ft · 1,210 N·m | 836 lb·ft · 1,133 N·m | +7% 828 Vario |
| Transmission | |||
| Top speed declared | 37.3 mph · 60 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | Multi-plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 40.2 gpm · 152 L/min | — | — |
| Pressure declared | 2,901 psi · 200 bar | 3,002 psi · 207 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 20,834 lb · 9,450 kg | 23,307 lb · 10,572 kg | +12% 8330 |
| Maximum permissible mass declared | — | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 114.2 in · 2,900 mm | 120.1 in · 3,050 mm | — |
| Length declared | 207.6 in · 5,274 mm | 233.8 in · 5,938 mm | +13% 8330 |
| Width declared | 103.1 in · 2,620 mm | 118.6–125.6 in · 3,012–3,190 mm | differs |
| Ground clearance declared | 22.3 in · 567 mm | 13.2 in · 336 mm | +69% 828 Vario |
| Fuel tank declared | 533.6 qt · 505 L | 720.0 qt · 681.4 L | +35% 8330 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fendt 828 Vario sources
- Source: Traktorenlexikon, “Fendt 828 Vario”
John Deere 8330 sources
- Source: Traktorenlexikon, “John Deere 8330”