8 material differences · fewer than 12
Tractor oneFahr F 221938–1940No measured PTO figureTractor twoLanz D 7506 Allzweck1939–1942No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (58%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | F 22 | D 7506 Allzweck | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.7 hp | 24.5 hp | +13% D 7506 Allzweck |
| Engine declared | Deutz F2M 414 | — | — |
| Displacement declared | 2.20 L | — | — |
| Maximum torque declared | 88 lb·ft · 120 N·m | — | — |
| Transmission | |||
| Top speed declared | 5.0–11.8 mph · 8.0–19.0 km/h | 11.0 mph · 17.7 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single plate clutch | Pedal operated three-jaw clutch with clutch brake | differs |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 540 rpm | 760 | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,012 lb · 1,820 kg | 6,349 lb · 2,880 kg | +58% D 7506 Allzweck |
| Maximum permissible mass declared | 4,850 lb · 2,200 kg | — | — |
| Wheelbase declared | 66.9 in · 1,700 mm | 69.1 in · 1,755 mm | — |
| Length declared | 110.2 in · 2,800 mm | 117.3 in · 2,980 mm | +6% D 7506 Allzweck |
| Width declared | 60.4 in · 1,535 mm | 65.7 in · 1,670 mm | +9% D 7506 Allzweck |
| Ground clearance declared | 11.4 in · 290 mm | 18.5 in · 470 mm | +62% D 7506 Allzweck |
| Fuel tank declared | 37.0 qt · 35 L | 52.8 qt · 50 L | +43% D 7506 Allzweck |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr F 22 sources
- Source: Traktorenlexikon, “Fahr F 22”
Lanz D 7506 Allzweck sources
- Source: Traktorenlexikon, “Lanz D 7506 Allzweck”