9 material differences · fewer than 12
Tractor oneFahr F 221938–1940No measured PTO figureTractor twoKramer KB 22 C1951–1954No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (56%); they were not built in overlapping years (1938–1940; 1951–1954). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | F 22 | KB 22 C | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.7 hp | 21 hp | — |
| Engine declared | Deutz F2M 414 | Güldner 2 DA | differs |
| Displacement declared | 2.20 L | 1.63 L | +35% F 22 |
| Maximum torque declared | 88 lb·ft · 120 N·m | 66 lb·ft · 89 N·m | +35% F 22 |
| Transmission | |||
| Top speed declared | 5.0–11.8 mph · 8.0–19.0 km/h | 12.4 mph · 20 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single plate clutch | Single-plate dry clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16.0 L/min | — |
| Pressure declared | — | 1,707 psi · 118 bar | — |
| Rear PTO speeds declared | 540 rpm | 528 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,012 lb · 1,820 kg | 2,579 lb · 1,170 kg | +56% F 22 |
| Maximum permissible mass declared | 4,850 lb · 2,200 kg | — | — |
| Wheelbase declared | 66.9 in · 1,700 mm | 68.1 in · 1,730 mm | — |
| Length declared | 110.2 in · 2,800 mm | 113.0 in · 2,870 mm | — |
| Width declared | 60.4 in · 1,535 mm | 60.6–61.0 in · 1,540–1,550 mm | — |
| Ground clearance declared | 11.4 in · 290 mm | 14.6 in · 370 mm | +28% KB 22 C |
| Fuel tank declared | 37.0 qt · 35 L | 21.1 qt · 20 L | +75% F 22 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr F 22 sources
- Source: Traktorenlexikon, “Fahr F 22”
Kramer KB 22 C sources
- Source: Traktorenlexikon, “Kramer KB 22 C”
- Source: Traktorenlexikon, “Güldner AF 20”