7 material differences · fewer than 12
Tractor oneFahr D 90 H1953–1956No measured PTO figureTractor twoInternational Harvester DLD 2 (McCormick)1953–1956No measured PTO figure
Which should you choose?
Read our verdict on the D 90 H and the DLD 2 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | D 90 H | DLD 2 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 11.8 hp | 13.8 hp | +17% DLD 2 |
| Engine declared | MWM AKD 12 E or AKD 112 E | INTERNATIONAL-HARVESTER DD-66 | differs |
| Displacement declared | 0.91 L | 1.09 L | +20% DLD 2 |
| Maximum torque declared | 33 lb·ft · 45 N·m | — | — |
| Transmission | |||
| Top speed declared | 11.4 mph · 18.3 km/h | 11.8 mph · 19 km/h | — |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch | Pedal operated dry Fichtel & Sachs single disc clutch | — |
| Hydraulics & hitch | |||
| Pressure declared | 3,129 psi · 216 bar | — | — |
| Rear PTO speeds declared | 588 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,491 lb · 1,130 kg | 1,808 lb · 820 kg | +38% D 90 H |
| Maximum permissible mass declared | 3,836 lb · 1,740 kg | — | — |
| Wheelbase declared | 59.8 in · 1,520 mm | 62.0 in · 1,575 mm | — |
| Length declared | 96.3 in · 2,447 mm | 96.9 in · 2,461 mm | — |
| Width declared | 58.7 in · 1,492 mm | 60.6 in · 1,540 mm | — |
| Ground clearance declared | 17.7 in · 450 mm | 14.2 in · 360 mm | +25% D 90 H |
| Turning radius, braked declared | 7.2 ft · 2.20 m | 8.0 ft · 2.45 m | +11% DLD 2 |
| Fuel tank declared | 20.1 qt · 19 L | 19.0 qt · 18.0 L | +6% D 90 H |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 90 H sources
- Source: Traktorenlexikon, “Fahr D 90 H”
- Source: Traktorenlexikon, “Fahr D 90”
International Harvester DLD 2 (McCormick) sources
- Source: Traktorenlexikon, “McCormick DLD 2”