6 material differences · fewer than 12
Tractor oneFahr D 22 PH1951–1953No measured PTO figureTractor twoFord 8 N1947–1952No measured PTO figure
Which should you choose?
Read our verdict on the D 22 PH and the 8 N → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | D 22 PH | 8 N | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.6 hp | 25.6 hp | +19% 8 N |
| Engine declared | Güldner 2 DA | — | — |
| Displacement declared | 1.63 L | — | — |
| Maximum torque declared | 71 lb·ft · 96 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 13.0 mph · 21 km/h | — |
| Clutch declared | — | Pedal operated dry single disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 3.4 gpm · 13.0 L/min | — |
| Pressure declared | 3,129 psi · 216 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,197 lb · 1,450 kg | 2,714 lb · 1,231 kg | +18% D 22 PH |
| Maximum permissible mass declared | 4,189 lb · 1,900 kg | — | — |
| Wheelbase declared | 64.4 in · 1,635 mm | 70.0 in · 1,778 mm | +9% 8 N |
| Length declared | 103.1 in · 2,620 mm | 115.0 in · 2,921 mm | +11% 8 N |
| Width declared | 61.5 in · 1,562 mm | 64.8 in · 1,645 mm | +5% 8 N |
| Ground clearance declared | 19.9 in · 506 mm | 21.0 in · 533 mm | +5% 8 N |
| Turning radius, braked declared | 7.6 ft · 2.33 m | 8.0 ft · 2.44 m | — |
| Fuel tank declared | 26.4 qt · 25 L | 48.1 qt · 45.5 L | +82% 8 N |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 22 PH sources
Source
- Source: Traktorenlexikon, “Fahr D 22 PH”
- Source: Traktorenlexikon, “Güldner AF 20”
Ford 8 N sources
Source
- Source: Traktorenlexikon, “Ford 8N”