10 material differences · fewer than 12
Tractor oneFahr D 22 P1951–1953No measured PTO figureTractor twoKramer KB 251953–1957No measured PTO figure
Which should you choose?
Read our verdict on the D 22 P and the KB 25 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 22 P | KB 25 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.6 hp | 24 hp | +12% KB 25 |
| Engine declared | Güldner 2 DA | Güldner 2 BN | differs |
| Displacement declared | 1.63 L | 1.84 L | +13% KB 25 |
| Maximum torque declared | 71 lb·ft · 96 N·m | 72 lb·ft · 98 N·m | — |
| Transmission | |||
| Top speed declared | 11.3 mph · 18.2 km/h | 12.4 mph · 20 km/h | +10% KB 25 |
| Clutch declared | — | Single-disc dry clutch from Fichtel & Sachs | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16 L/min | — |
| Pressure declared | 3,129 psi · 216 bar | 1,707 psi · 118 bar | +83% D 22 P |
| Rear PTO speeds declared | 540 rpm | 405/710/1089 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,976 lb · 1,350 kg | 3,307 lb · 1,500 kg | +11% KB 25 |
| Maximum permissible mass declared | 4,189 lb · 1,900 kg | — | — |
| Wheelbase declared | 64.6 in · 1,640 mm | 72.2 in · 1,835 mm | +12% KB 25 |
| Length declared | 101.2 in · 2,570 mm | 114.2 in · 2,900 mm | +13% KB 25 |
| Width declared | 61.5 in · 1,562 mm | 62.2 in · 1,580 mm | — |
| Ground clearance declared | 16.1 in · 410 mm | 15.0 in · 380 mm | +8% D 22 P |
| Turning radius, braked declared | 7.6 ft · 2.33 m | — | — |
| Fuel tank declared | 33.8 qt · 32 L | 21.1 qt · 20 L | +60% D 22 P |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 22 P sources
- Source: Traktorenlexikon, “Fahr D 22 P”
- Source: Traktorenlexikon, “Güldner AF 20”
Kramer KB 25 sources
- Source: Traktorenlexikon, “Kramer KB 25”
- Source: Traktorenlexikon, “Kramer KB 22 W”