7 material differences · fewer than 12
Tractor oneFahr D 160 H1954–1956No measured PTO figureTractor twoGüldner ALB1955–1958No measured PTO figure
Which should you choose?
Read our verdict on the D 160 H and the ALB → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | D 160 H | ALB | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 21.6 hp | 21.6 hp | — |
| Engine declared | Güldner 2 DA | Güldner 2 LB | differs |
| Displacement declared | 1.63 L | 1.84 L | +13% ALB |
| Maximum torque declared | 71 lb·ft · 96 N·m | 65 lb·ft · 88 N·m | +9% D 160 H |
| Transmission | |||
| Top speed declared | 12.3 mph · 19.8 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | — | Pedal-operated dry single-plate clutch from Fichtel & Sachs | — |
| Hydraulics & hitch | |||
| Pressure declared | 3,129 psi · 216 bar | 1,991 psi · 137 bar | +58% D 160 H |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,252 lb · 1,475 kg | 3,086 lb · 1,400 kg | +5% D 160 H |
| Maximum permissible mass declared | 4,409 lb · 2,000 kg | 3,968 lb · 1,800 kg | +11% D 160 H |
| Wheelbase declared | 71.8 in · 1,824 mm | 74.3 in · 1,886 mm | — |
| Length declared | 110.6 in · 2,810 mm | 114.2 in · 2,900 mm | — |
| Width declared | 61.5 in · 1,562 mm | 62.4 in · 1,585 mm | — |
| Ground clearance declared | 18.3 in · 465 mm | 17.7 in · 450 mm | — |
| Turning radius, braked declared | 8.2 ft · 2.50 m | — | — |
| Fuel tank declared | 26.4 qt · 25 L | 38.0 qt · 36 L | +44% ALB |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 160 H sources
Source
- Source: Traktorenlexikon, “Fahr D 160 H”
- Source: Traktorenlexikon, “Güldner AF 20”
Güldner ALB sources
Source
- Source: Traktorenlexikon, “Güldner ALB”
- Source: Traktorenlexikon, “Güldner A 2 BL”