7 material differences · fewer than 12
Tractor oneFahr D 133 T1959–1961No measured PTO figureTractor twoFahr D 185 H1956No measured PTO figure
Which should you choose?
Read our verdict on the D 133 T and the D 185 H → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | D 133 T | D 185 H | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 24.5 hp | 24.7 hp | — |
| Engine declared | Güldner 3 LKN | Güldner 2 LBN | differs |
| Displacement declared | 1.32 L | 1.84 L | +39% D 185 H |
| Maximum torque declared | 53 lb·ft · 72 N·m | 66 lb·ft · 89 N·m | +24% D 185 H |
| Transmission | |||
| Top speed declared | 12.2 mph · 19.7 km/h | 12.4 mph · 20 km/h | — |
| Clutch declared | Dry Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Pressure declared | — | 2,845 psi · 196 bar | — |
| Rear PTO speeds declared | — | 562 | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,142 lb · 1,425 kg | 3,203 lb · 1,453 kg | — |
| Maximum permissible mass declared | 4,409 lb · 2,000 kg | 4,409 lb · 2,000 kg | — |
| Wheelbase declared | 78.7 in · 2,000 mm | 71.8 in · 1,824 mm | +10% D 133 T |
| Length declared | 133.1 in · 3,380 mm | 110.9 in · 2,816 mm | +20% D 133 T |
| Width declared | 60.0 in · 1,525 mm | 61.5 in · 1,562 mm | — |
| Ground clearance declared | 16.3 in · 415 mm | 15.7 in · 400 mm | — |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 8.2 ft · 2.50 m | +26% D 133 T |
| Fuel tank declared | 37.0 qt · 35 L | 31.7 qt · 30 L | +17% D 133 T |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fahr D 133 T sources
- Source: Traktorenlexikon, “Fahr D 133 T”
- Source: Traktorenlexikon, “Fahr D 133 N”
Fahr D 185 H sources
- Source: Traktorenlexikon, “Fahr D 185 H”