10 material differences · fewer than 12
Tractor oneEicher 3056 AS1982–1990No measured PTO figureTractor twoLandini 6030 (DT) TL-39 N/B (TL-39 DT/B)1983–1987No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (44%); the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 3056 AS | 6030 (DT) TL-39 N/B (TL-39 DT/B) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 55 hp | 55.3 hp | — |
| Engine declared | Eicher EDL 3-8 | Perkins AT 3.152-4 | differs |
| Displacement declared | 2.93 L | 2.50 L | +17% 3056 AS |
| Maximum torque declared | — | 131 lb·ft · 178 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Dry and air-cooled OMG or LuK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 11.6 gpm · 44.0 L/min | 9.6 gpm · 36.5 L/min | +21% 3056 AS |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540 rpm / 750 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,176 lb · 3,255 kg | 4,971 lb · 2,255 kg | +44% 3056 AS |
| Maximum permissible mass declared | 8,818 lb · 4,000 kg | — | — |
| Wheelbase declared | 92.5 in · 2,350 mm | 81.9 in · 2,080 mm | +13% 3056 AS |
| Length declared | 141.3 in · 3,590 mm | 138.2 in · 3,510 mm | — |
| Width declared | 78.5 in · 1,995 mm | 75.6 in · 1,920 mm | — |
| Ground clearance declared | 14.0 in · 355 mm | 19.5 in · 495 mm | +39% 6030 (DT) TL-39 N/B (TL-39 DT/B) |
| Turning radius, braked declared | 14.4 ft · 4.40 m | 12.4 ft · 3.79 m | +16% 3056 AS |
| Fuel tank declared | 103.6 qt · 98 L | 63.9 qt · 60.5 L | +62% 3056 AS |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher 3056 AS sources
- Source: Traktorenlexikon, “Eicher 3056 A”
- Source: Traktorenlexikon, “Eicher 656 PA”
Landini 6030 (DT) TL-39 N/B (TL-39 DT/B) sources
- Source: Traktorenlexikon, “Landini 6030 (DT)”
- Source: Traktorenlexikon, “Massey Ferguson MF 253”