6 material differences · fewer than 12
Tractor oneEicher 3048 AS1982–1990No measured PTO figureTractor twoHanomag Granit 501 E (S)1967–1970No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (49%); the drive differs (4WD; 2WD); they were not built in overlapping years (1982–1990; 1967–1970). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 3048 AS | Granit 501 E (S) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47 hp | 47 hp | — |
| Engine declared | Eicher EDL 3 - 7 | — | — |
| Displacement declared | 2.93 L | — | — |
| Maximum torque declared | — | 109 lb·ft · 148 N·m | — |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 12.4–16.9 mph · 20.0–27.2 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.9 gpm · 26 L/min | — | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 750 rpm / 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,099 lb · 3,220 kg | 4,762 lb · 2,160 kg | +49% 3048 AS |
| Maximum permissible mass declared | 7,716 lb · 3,500 kg | 7,606 lb · 3,450 kg | — |
| Wheelbase declared | 92.5 in · 2,350 mm | 82.7 in · 2,100 mm | +12% 3048 AS |
| Length declared | 139.2 in · 3,535 mm | 134.6 in · 3,420 mm | — |
| Width declared | 78.5 in · 1,995 mm | 69.5 in · 1,765 mm | +13% 3048 AS |
| Ground clearance declared | — | 15.4 in · 390 mm | — |
| Turning radius, braked declared | 12.5 ft · 3.80 m | 10.5 ft · 3.20 m | +19% 3048 AS |
| Fuel tank declared | 103.6 qt · 98 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Eicher 3048 AS sources
- Source: Traktorenlexikon, “Eicher 3048 A”
- Source: Traktorenlexikon, “Eicher 645 K”
Hanomag Granit 501 E (S) sources
- Source: Traktorenlexikon, “Hanomag Granit 501 E (S)”