4 material differences · fewer than 12
Tractor oneDoppstadt Trac 1601999–2001No measured PTO figureTractor twoFendt Favorit 716 Variofrom 1998No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1999–2001; 1998–1998). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
4 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Trac 160 | Favorit 716 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 158 hp | 158 hp | — |
| Engine declared | — | Deutz AG BF6M 2013 C | — |
| Displacement declared | — | 5.70 L | — |
| Maximum torque declared | — | 558 lb·ft · 757.0 N·m | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% Favorit 716 Vario |
| Clutch declared | — | Multi-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | — | 29.1 gpm · 110 L/min | — |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/750/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 15,829 lb · 7,180 kg | 12,787–14,451 lb · 5,800–6,555 kg | differs |
| Maximum permissible mass declared | — | 24,251 lb · 11,000 kg | — |
| Wheelbase declared | 110.2 in · 2,800 mm | 106.3 in · 2,700 mm | — |
| Length declared | 188.6 in · 4,790 mm | 182.7–183.2 in · 4,640–4,653 mm | — |
| Width declared | 98.4 in · 2,500 mm | 101.2–102.0 in · 2,570–2,590 mm | — |
| Ground clearance declared | 27.2 in · 690 mm | 22.7 in · 576 mm | +20% Trac 160 |
| Turning radius, braked declared | — | 16.1 ft · 4.90 m | — |
| Fuel tank declared | — | 322.3 qt · 305 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Doppstadt Trac 160 sources
- Source: Traktorenlexikon, “Doppstadt Trac 160”
Fendt Favorit 716 Vario sources
- Source: Traktorenlexikon, “Fendt Favorit 716 Vario”
- Source: OECD test report 1884, 2000