7 material differences · fewer than 12
Tractor oneDexheimer Allrad 345 N1976–1985No measured PTO figureTractor twoSOMECA 500 Special (TD)1972–1983No measured PTO figure
Which should you choose?
Read our verdict on the Allrad 345 N and the 500 Special (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Allrad 345 N | 500 Special (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50 hp | 49.3 hp | — |
| Engine declared | — | FIAT-IVECO 8035.02.203/303 | — |
| Displacement declared | — | 2.59 L | — |
| Maximum torque declared | — | 116 lb·ft · 157 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.8 gpm · 41 L/min | 5.8 gpm · 21.8 L/min | +88% Allrad 345 N |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | — | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,583 lb · 1,625 kg | 4,145 lb · 1,880 kg | +16% 500 Special (TD) |
| Wheelbase declared | 81.1 in · 2,060 mm | 76.9 in · 1,953 mm | +5% Allrad 345 N |
| Length declared | 114.2 in · 2,900 mm | 119.7 in · 3,041 mm | — |
| Width declared | 39.8 in · 1,010 mm | 65.4–87.8 in · 1,660–2,230 mm | differs |
| Ground clearance declared | 10.6 in · 270 mm | 18.1 in · 459 mm | +70% 500 Special (TD) |
| Turning radius, braked declared | 6.9 ft · 2.10 m | 9.7 ft · 2.95 m | +40% 500 Special (TD) |
| Fuel tank declared | 52.8 qt · 50 L | 57.1 qt · 54.0 L | +8% 500 Special (TD) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Dexheimer Allrad 345 N sources
- Source: Traktorenlexikon, “Dexheimer ALLRAD 345 N”
SOMECA 500 Special (TD) sources
- Source: Traktorenlexikon, “Someca 500 S”