8 material differences · fewer than 12
Tractor oneDexheimer Allrad 345 N1976–1985No measured PTO figureTractor twoNew Holland 3935 (A)1969–1999No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Allrad 345 N | 3935 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50 hp | 49.3 hp | — |
| Engine declared | — | IVECO 8035.06 | — |
| Displacement declared | — | 2.71 L | — |
| Maximum torque declared | — | 114 lb·ft · 155 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 10.8 gpm · 41 L/min | 8.7 gpm · 32.8 L/min | +25% Allrad 345 N |
| Rear PTO speeds declared | — | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,583 lb · 1,625 kg | 4,255 lb · 1,930 kg | +19% 3935 (A) |
| Maximum permissible mass declared | — | 8,488 lb · 3,850 kg | — |
| Wheelbase declared | 81.1 in · 2,060 mm | 78.7 in · 1,999 mm | — |
| Length declared | 114.2 in · 2,900 mm | 127.6 in · 3,241 mm | +12% 3935 (A) |
| Width declared | 39.8 in · 1,010 mm | 60.6–84.3 in · 1,540–2,140 mm | differs |
| Ground clearance declared | 10.6 in · 270 mm | 14.8 in · 375 mm | +39% 3935 (A) |
| Turning radius, braked declared | 6.9 ft · 2.10 m | 9.9 ft · 3.03 m | +44% 3935 (A) |
| Fuel tank declared | 52.8 qt · 50 L | 44.4 qt · 42.0 L | +19% Allrad 345 N |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Dexheimer Allrad 345 N sources
- Source: Traktorenlexikon, “Dexheimer ALLRAD 345 N”
New Holland 3935 (A) sources
- Source: Traktorenlexikon, “New Holland 3935”
- Source: Traktorenlexikon, “New Holland 3435”