6 material differences · fewer than 12
Tractor oneDeutz (KHD) Intrac 20041978–1989No measured PTO figureTractor twoLandini R-7500 (DT)1978–1987No measured PTO figure
Which should you choose?
Read our verdict on the Intrac 2004 and the R-7500 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Intrac 2004 | R-7500 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 68.7 hp | 69.1 hp | — |
| Engine declared | KHD F4L 912 H | Perkins LD.22756 (A 4.236) | differs |
| Displacement declared | 3.77 L | 3.87 L | — |
| Maximum torque declared | 175 lb·ft · 237 N·m | 198 lb·ft · 268 N·m | +13% R-7500 (DT) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | — | Dry LUK double clutch, pedal-operated driving clutch and hand lever-operated PTO clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 12.4 gpm · 47.1 L/min | — | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,055 lb · 3,200 kg | 6,896 lb · 3,128 kg | — |
| Maximum permissible mass declared | 11,795 lb · 5,350 kg | — | — |
| Wheelbase declared | 86.6 in · 2,200 mm | 96.9 in · 2,460 mm | +12% R-7500 (DT) |
| Length declared | 140.2 in · 3,560 mm | 150.8 in · 3,830 mm | +8% R-7500 (DT) |
| Width declared | 79.7 in · 2,025 mm | 77.6 in · 1,970 mm | — |
| Ground clearance declared | 14.0 in · 355 mm | 17.7 in · 450 mm | +27% R-7500 (DT) |
| Turning radius, braked declared | — | 11.2 ft · 3.42 m | — |
| Fuel tank declared | — | 64.5 qt · 61.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) Intrac 2004 sources
- Source: Traktorenlexikon, “Deutz INTRAC 2004”
Landini R-7500 (DT) sources
- Source: Traktorenlexikon, “Landini 7550”