7 material differences · fewer than 12
Tractor oneDeutz (KHD) Intrac 20041978–1989No measured PTO figureTractor twoFendt Farmer 270 P/PA1987–1996No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (28%); the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | Intrac 2004 | Farmer 270 P/PA | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 68.7 hp | 68 hp | — |
| Engine declared | KHD F4L 912 H | KHD F4L 912 | differs |
| Displacement declared | 3.77 L | 3.77 L | — |
| Maximum torque declared | 175 lb·ft · 237 N·m | 180 lb·ft · 244 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 12.4 gpm · 47.1 L/min | 17.4 gpm · 66.0 L/min | +40% Farmer 270 P/PA |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/750 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,055 lb · 3,200 kg | 5,512 lb · 2,500 kg | +28% Intrac 2004 |
| Maximum permissible mass declared | 11,795 lb · 5,350 kg | 8,818 lb · 4,000 kg | +34% Intrac 2004 |
| Wheelbase declared | 86.6 in · 2,200 mm | 85.8 in · 2,180 mm | — |
| Length declared | 140.2 in · 3,560 mm | 143.5 in · 3,646 mm | — |
| Width declared | 79.7 in · 2,025 mm | 65.6 in · 1,666 mm | +22% Intrac 2004 |
| Ground clearance declared | 14.0 in · 355 mm | 10.1 in · 257 mm | +38% Intrac 2004 |
| Turning radius, braked declared | — | 10.8 ft · 3.30 m | — |
| Fuel tank declared | — | 63.4 qt · 60 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) Intrac 2004 sources
- Source: Traktorenlexikon, “Deutz INTRAC 2004”
Fendt Farmer 270 P/PA sources
- Source: Traktorenlexikon, “Fendt Farmer 270 P/PA”
- Source: Traktorenlexikon, “Deutz D 6006”