9 material differences · fewer than 12
Tractor oneDeutz (KHD) Intrac 20021972–1974No measured PTO figureTractor twoJohn Deere 1130 (A)1974–1977No measured PTO figure
Which should you choose?
Read our verdict on the Intrac 2002 and the 1130 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Intrac 2002 | 1130 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50.0 hp | 50.3 hp | — |
| Engine declared | KHD F3L 912 H | John Deere 3.164 DL-13 | differs |
| Displacement declared | 2.83 L | 2.70 L | — |
| Maximum torque declared | 135 lb·ft · 182 N·m | 136 lb·ft · 185 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Pump flow declared | — | 6.3 gpm · 24.0 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | 3,481–4,496 psi · 240–310 bar | differs |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,908 lb · 2,680 kg | 5,051 lb · 2,291 kg | +17% Intrac 2002 |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 84.6 in · 2,150 mm | 80.7 in · 2,050 mm | — |
| Length declared | 137.8 in · 3,500 mm | 133.3 in · 3,385 mm | — |
| Width declared | 74.4 in · 1,890 mm | 73.4–91.7 in · 1,865–2,330 mm | differs |
| Ground clearance declared | 17.9 in · 455 mm | 25.6 in · 650 mm | +43% 1130 (A) |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 10.3 ft · 3.13 m | +18% Intrac 2002 |
| Fuel tank declared | 91.9 qt · 87 L | 66.0 qt · 62.5 L | +39% Intrac 2002 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) Intrac 2002 sources
- Source: Traktorenlexikon, “Deutz INTRAC 2002”
John Deere 1130 (A) sources
- Source: Traktorenlexikon, “John Deere 1130”