6 material differences · fewer than 12
Tractor oneDeutz (KHD) Intrac 20021972–1974No measured PTO figureTractor twoDexheimer Allrad 345 N1976–1985No measured PTO figure
Which should you choose?
Read our verdict on the Intrac 2002 and the Allrad 345 N → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Intrac 2002 | Allrad 345 N | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 50.0 hp | 50 hp | — |
| Engine declared | KHD F3L 912 H | — | — |
| Displacement declared | 2.83 L | — | — |
| Maximum torque declared | 135 lb·ft · 182 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 10.8 gpm · 41 L/min | — |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | — | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,908 lb · 2,680 kg | 3,583 lb · 1,625 kg | +65% Intrac 2002 |
| Wheelbase declared | 84.6 in · 2,150 mm | 81.1 in · 2,060 mm | — |
| Length declared | 137.8 in · 3,500 mm | 114.2 in · 2,900 mm | +21% Intrac 2002 |
| Width declared | 74.4 in · 1,890 mm | 39.8 in · 1,010 mm | +87% Intrac 2002 |
| Ground clearance declared | 17.9 in · 455 mm | 10.6 in · 270 mm | +69% Intrac 2002 |
| Turning radius, braked declared | 12.1 ft · 3.70 m | 6.9 ft · 2.10 m | +76% Intrac 2002 |
| Fuel tank declared | 91.9 qt · 87 L | 52.8 qt · 50 L | +74% Intrac 2002 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz (KHD) Intrac 2002 sources
- Source: Traktorenlexikon, “Deutz INTRAC 2002”
Dexheimer Allrad 345 N sources
- Source: Traktorenlexikon, “Dexheimer ALLRAD 345 N”