9 material differences · fewer than 12
Tractor oneDeutz-Fahr DX 50 V1978–1985No measured PTO figureTractor twoWHITE 431986–1988No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1978–1985; 1986–1988). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DX 50 V | 43 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 45.2 hp | 44.9 hp | — |
| Engine declared | KHD F3L 912 | ISUZU C-240 | differs |
| Displacement declared | 2.83 L | 2.38 L | +19% DX 50 V |
| Maximum torque declared | 110 lb·ft · 149 N·m | 98 lb·ft · 133 N·m | +12% DX 50 V |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 15.5 mph · 25 km/h | +14% 43 |
| Clutch declared | Independent dry double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 8.4 gpm · 31.8 L/min | — |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,461 lb · 1,570 kg | 3,748 lb · 1,700 kg | +8% 43 |
| Wheelbase declared | 70.5 in · 1,790 mm | 79.3 in · 2,015 mm | +13% 43 |
| Length declared | 126.0 in · 3,200 mm | 136.4 in · 3,465 mm | +8% 43 |
| Width declared | 43.3 in · 1,100 mm | 61.2 in · 1,555 mm | +41% 43 |
| Ground clearance declared | 13.8 in · 350 mm | 13.6 in · 345 mm | — |
| Turning radius, braked declared | 9.5 ft · 2.89 m | 9.3 ft · 2.85 m | — |
| Fuel tank declared | 42.3 qt · 40 L | 52.8 qt · 50.0 L | +25% 43 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Deutz-Fahr DX 50 V sources
- Source: Traktorenlexikon, “Deutz-Fahr DX 50 V”
- Source: Traktorenlexikon, “Deutz D 4006 P”
WHITE 43 sources
- Source: Traktorenlexikon, “White 43”