Deutz-Fahr DX 3.80 AS or SAME Jaguar 95 (DT)?
Which should you choose?
On performance, every comparable figure that differs favours the SAME Jaguar 95 (DT): three-point lift.
- The SAME Jaguar 95 (DT) suits loader and hydraulic implement work better on this data: 77% (1,840 kg / 4,057 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | DX 3.80 AS | Jaguar 95 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 49.4 kW (66.2 hp)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 49.2 kW (66.0 hp)Traktorenlexikon, “SAME Jaguar 95” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the DX 3.80 AS and the Jaguar 95 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the DX 3.80 AS and the Jaguar 95 (DT). |
| Which pumps more oil for implements? | 40.0 L/min (10.6 gpm)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | — | No figureNo call on hydraulic flow: no figure on record for the Jaguar 95 (DT). |
| Which lifts more on the three-point hitch? | 2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 4,240 kg (9,348 lb)Traktorenlexikon, “SAME Jaguar 95” | AheadThe SAME Jaguar 95 (DT) has 77% more lift (1,840 kg / 4,057 lb) than the Deutz-Fahr DX 3.80 AS (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 3,300 kg (7,275 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 3,610 kg (7,959 lb)Traktorenlexikon, “SAME Jaguar 95” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | 4,000 kg (8,818 lb)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | — | No figureNo call on maximum permissible mass: no figure on record for the Jaguar 95 (DT). |
| Which has the wider choice of gears? | 16Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 12 to 24Traktorenlexikon, “SAME Jaguar 95” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the DX 3.80 AS and the Jaguar 95 (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “SAME Jaguar 95” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | 540/1000 rpmTraktorenlexikon, “SAME Jaguar 95” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | independentTraktorenlexikon, “SAME Jaguar 95” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Deutz-Fahr DX 3.80 AS” | Two-wheel or four-wheel driveTraktorenlexikon, “SAME Jaguar 95” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1985–1990 | 1979–1982 | Ahead (a fact, not an advantage)The Deutz-Fahr DX 3.80 AS is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The SAME Jaguar 95 (DT) has 77% more lift (1,840 kg / 4,057 lb) than the Deutz-Fahr DX 3.80 AS (both lift at the hitch ends, as stated by the source).
- The Deutz-Fahr DX 3.80 AS is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources